Masana Energy Solutions HSS Customer Guide

Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Commission Regulation (EU) 2015/830 Recommended monitoring procedures If this product contains ingredients with exposure limits, personal, workplace atmosphere or biological monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory protective equipment. Reference should be made to monitoring standards, such as the following: European Standard EN 689 (Workplace atmospheres - Guidance for the assessment of exposure by inhalation to chemical agents for comparison with limit values and measurement strategy) European Standard EN 14042 (Workplace atmospheres - Guide for the application and use of procedures for the assessment of exposure to chemical and biological agents) European Standard EN 482 (Workplace atmospheres - General requirements for the performance of procedures for the measurement of chemical agents) Reference to national guidance documents for methods for the determination of hazardous substances will also be required. Respiratory protection Appropriate engineering controls Provide exhaust ventilation or other engineering controls to keep the relevant airborne concentrations below their respective occupational exposure limits. All activities involving chemicals should be assessed for their risks to health, to ensure exposures are adequately controlled. Personal protective equipment should only be considered after other forms of control measures (e.g. engineering controls) have been suitably evaluated. Personal protective equipment should conform to appropriate standards, be suitable for use, be kept in good condition and properly maintained. Your supplier of personal protective equipment should be consulted for advice on selection and appropriate standards. For further information contact your national organisation for standards. The final choice of protective equipment will depend upon a risk assessment. It is important to ensure that all items of personal protective equipment are compatible. Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Ensure that eyewash stations and safety showers are close to the workstation location. 8.2 Exposure controls Hygiene measures Fuel oil, residual DNEL Short term Inhalation 15 minutes 4700 mg/m³ Workers Systemic DNEL Long term Dermal 8 hours TWA 0.065 mg/kg bw/day Workers Systemic DNEL Long term Inhalation 8 hours TWA 0.12 mg/m³ Workers Systemic DNEL Long term Oral 24 hours TWA 0.015 mg/kg bw/day General population Systemic Product/ingredient name Exposure Value Population Effects Predicted No Effect Concentration No PNECs available SECTION 8: Exposure controls/personal protection The information in this section contains generic advice and guidance. The list of Identified Uses in Section 1 should be consulted for any available use-specific information provided in the Exposure Scenario(s). 8.1 Control parameters Derived No Effect Level Type Individual protection measures Whilst specific OELs for certain components may be shown in this section, other components may be present in any mist, vapour or dust produced. Therefore, the specific OELs may not be applicable to the product as a whole and are provided for guidance only. If local exhaust ventilation or other methods of ventilation are not possible or are insufficient, wear suitable respiratory protective devices. Wear suitable respiratory protective devices if there is a risk of exposure limits being exceeded. The choice of suitable respiratory device will depend upon a risk assessment of the workplace environment and the task being carried out. If required, the respiratory device must be certified as safe in defined explosive atmospheres (EX Label). Respiratory protective devices must be checked to ensure they fit correctly each time they are worn. Please consult European standard EN 529 for further guidance on the selection, use, care and maintenance of respiratory protective devices. Suitable breathing apparatus (independent of ambient atmosphere) must be worn if any of the following situations apply. Occupational exposure limits Hydrogen Sulphide [Air contaminant] EH40/2005 WELs (United Kingdom (UK)). STEL: 14 mg/m³ 15 minutes. Issued/Revised: 12/2001 STEL: 10 ppm 15 minutes. Issued/Revised: 12/2001 TWA: 7 mg/m³ 8 hours. Issued/Revised: 12/2001 TWA: 5 ppm 8 hours. Issued/Revised: 12/2001 Product name Version 12 Fuel Oil, residual Page: 7/38 STI2299 Product code Date of issue 23 March 2021 Format United Kingdom (UK) Language ENGLISH (United Kingdom) Date of previous issue 2 November 2020.