Masana Energy Solutions HSS Customer Guide

Section 7. Handling and storage spillages, represent a fire hazard, and should not be allowed to accumulate. Dispose of safely immediately after use. Section 8. Exposure controls/personal protection Control parameters Recommended monitoring procedures If this product contains ingredients with exposure limits, personal, workplace atmosphere or biological monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory protective equipment. Reference should be made to appropriate monitoring standards. Reference to national guidance documents for methods for the determination of hazardous substances will also be required. Hand protection Eye protection Environmental exposure controls Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. In some cases, fume scrubbers, filters or engineering modifications to the process equipment will be necessary to reduce emissions to acceptable levels. Appropriate engineering controls Provide exhaust ventilation or other engineering controls to keep the relevant airborne concentrations below their respective occupational exposure limits. All activities involving chemicals should be assessed for their risks to health, to ensure exposures are adequately controlled. Personal protective equipment should only be considered after other forms of control measures (e.g. engineering controls) have been suitably evaluated. Personal protective equipment should conform to appropriate standards, be suitable for use, be kept in good condition and properly maintained. Your supplier of personal protective equipment should be consulted for advice on selection and appropriate standards. For further information contact your national organisation for standards. The final choice of protective equipment will depend upon a risk assessment. It is important to ensure that all items of personal protective equipment are compatible. Hygiene measures Individual protection measures Skin protection Ingredient name Exposure limits Gasoline ACGIH TLV (United States). TWA: 300 ppm 8 hours. Issued/Revised: 5/1996 TWA: 890 mg/m³ 8 hours. Issued/Revised: 5/1996 STEL: 500 ppm 15 minutes. Issued/ Revised: 5/1996 STEL: 1480 mg/m³ 15 minutes. Issued/ Revised: 5/1996 Ethanol DOL OEL (South Africa). TWA: 1900 mg/m³ 8 hours. Issued/Revised: 8/1995 TWA: 1000 ppm 8 hours. Issued/Revised: 8/1995 Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location. Chemical splash goggles. Wear chemical resistant gloves. Do not re-use gloves. Protective gloves must give suitable protection against mechanical risks (i.e. abrasion, blade cut and puncture). Protective gloves will deteriorate over time due to physical and chemical damage. Inspect and replace gloves on a regular basis. The frequency of replacement will depend upon the circumstances of use. Occupational exposure limits Whilst specific OELs for certain components may be shown in this section, other components may be present in any mist, vapour or dust produced. Therefore, the specific OELs may not be applicable to the product as a whole and are provided for guidance only. Date of issue Page: 5/11 BP Ultimate ULP 93/95 with Active Technology Product name Product code Version Format Language GHS - South Africa SSA9014 Build 6.1.0 ENGLISH (ENGLISH) (GHS - Default) 24/06/2021. 1.02